Land Rover Defender: Clearsight rear-view mirror
The ClearSight rear-view mirror has a limited view. The driver is responsible for detecting obstacles and estimating the vehicle's distance from them when maneuvering the vehicle. Driver distraction can lead to accidents, potentially causing serious injury or death.
When cleaning the ClearSight rear-view mirror's glass, use a paper towel, or similar material, dampened with glass cleaner.
Do not spray glass cleaner directly on to the mirror, as that may cause the liquid cleaner to enter the mirror's housing and damage the mirror.
The ClearSight rear-view mirror uses a camera and a mirror-integrated display.
The ClearSight rear-view mirror's camera mode displays a wide-angle camera view of the area behind the vehicle.
Alternatively, use the ClearSight rear-view mirror as a conventional mirror.
- HomeLink buttons.
- ClearSight rear-view mirror mode switch.
- ClearSight rear-view mirror settings button.
- ClearSight rear-view mirror settings adjuster button - Down.
- ClearSight rear-view mirror settings adjuster button - Up.
To enable the ClearSight rear-view mirror's camera mode, pull the ClearSight rear-view mirror mode switch (2) rearward.
Push the mode switch (2) forward to disable.
The user can adjust the following ClearSight rear-view mirror settings:
- Brightness: Press the settings button (3). Adjust the brightness levels using the up (5) and down (4) buttons.
- Height: Press the settings button twice.
Adjust the height using the up (5) and down (4) buttons.
If a ClearSight rear-view mirror system fault is detected, the rear-view mirror displays a camera disabled icon.¹ If the camera display is not available, place the ClearSight rear-view mirror in to mirror mode, and contact a retailer/authorized repairer.
HomeLink is a registered trademark of Gentex Corporation.
Camera disabled icon.¹
AUTO-DIMMING INTERIOR REAR VIEW MIRROR
Note: The operation of the center sun visor may affect the operation of the auto-dimming interior rear view mirror.
READ NEXT:
Radio frequency (RF) transceiver
Make sure the following warnings have
been read and fully understood before
using the garage door opener. Failure to
use the garage door opener safely could
result in an accident, leading to serious
i
Programming
Note: The instructions below apply to the
majority of HomeLink compatible
systems. However, there are some
HomeLink applications, or HomeLink
compatible systems, that require slightly
different instru
SEE MORE:
Auxiliary power sockets
Only use approved accessories. Using any
other equipment may damage the
vehicle's electrical system. If in any doubt,
contact a retailer/authorized repairer.
The engine should be running when using
electrical accessories for long periods.
Failure to do so can discharge the battery.
Note: 12 V pow
Driver Seat Module
REMOVAL AND INSTALLATION
GENERAL EQUIPMENT
REMOVAL
WARNINGS:
To avoid accidental deployment, the Restraints Control Module (RCM)
backup power supply must be
depleted. Wait at least 2 minutes after disconnecting the startup battery
ground cable(s) before doing any
repair or adjustment to the
