Land Rover Defender: Vehicle Dynamic Suspension - Description and Operation
Land Rover Defender 2020-2024 Service Manual / Chassis / Vehicle Dynamic Suspension / Vehicle Dynamic Suspension - Description and Operation
READ NEXT:
Component Location, Overview
COMPONENT LOCATION
COMPONENT LOCATION 1 OF 2 - MODEL 110 VEHICLES
Rear left height sensor
Chassis Control Module (CHCM)
Interactive Control Interface Module 'A' (ICIMA)
Interactive Display Modul
Description
SHOCK ABSORBERS
The adaptive shock absorbers are nitrogen gas and oil filled monotube units.
The shock absorbers are continuously
variable, which allows the damping force to be electrically adjusted
Operation
CHASSIS CONTROL MODULE
The CHCM uses a combination of information from other system modules and data
from the accelerometers and
suspension height sensors to measure the vehicle and suspension states
SEE MORE:
Autonomous emergency braking (AEB) limitations
Vehicle detection Autonomous Emergency
Braking (AEB) does not operate if:
The vehicle is negotiating a tight
corner.
The forward-facing cameras are dirty
or obscured.
The forward-facing radars are dirty or
obscured.
Note: The fitting of forward-facing
radars depends on the vehicle
specific
Rear Air Reservoir Valve Block
REMOVAL AND INSTALLATION
PART(S)
REMOVAL
WARNING:
Residual air pressure may be present in the system. Take care when releasing air
line connectors.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from
foreign material. When
disconnected all openings must be sea
© 2010-2024 Copyright www.lrdefender.org
