Land Rover Defender: Frame and Mounting
Uni-Body, Subframe and Mounting System
SPECIFICATIONS
Torque Specification
NOTE:
Numbers with green background are a single use components.
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
COMPONENT TORQUE LOCATION
READ NEXT:
GENERAL PROCEDURES
CHECK
CAUTIONS:
If one hole/thread is damaged, all remaining holes/threads must have
a steel insert installed.
Make sure that the drill speed is not at maximum when repairing t
GENERAL PROCEDURES
SPECIAL TOOL(S)
JLR-502-041
Steel Subframe Insert Kit
ACTIVATION
CAUTION:
Make sure that the drill speed is not at maximum when repairing the damaged
hole/thread. Use a suitable
e
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
JLR-303-1676
Engine lifting eyes
JLR-303-1692
Engine Support
JLR-303-1692-01
Engine Support Adapter
JLR-303-1713
Engine Brace Mountings
GENERAL EQUIPMENT
SEE MORE:
REMOVAL AND INSTALLATION
REMOVAL
CAUTION:
Do not use excessive force to remove the component. Make sure that all fixings
are fully released.
NOTE:
This procedure contains some variation in the illustrations depending
on the vehicle specification, but the
essential information is always correct
REMOVAL AND INSTALLATION
SPECIAL TOOL(S)
100-012
Slide Hammer
100-012-01
Slide Hammer Adapter
307-520
Installer, Output Shaft Seal
308-375
Remover, Input and Output Seal
JLR-307-520-01
Adapter, Output Shaft Seal
REMOVAL
NOTE:
This procedure contains some variation in the illustrations dependi
© 2010-2025 Copyright www.lrdefender.org